Electrical Final Standards Checklist

Section 1: Final Installation & Commissioning Checklist

• Devices installed neatly and aligned: All switches, receptacles, and cover plates
  installed straight, level, and flush with wall surfaces.
• Lighting fixtures installed correctly: Fixtures mounted securely, centered, and
  oriented per design with no damage or missing parts.
• All bulbs and trims installed: Verify all specified lamps and trims are installed,
  functional, and matching design intent.
• Panel labeling completed: All circuits clearly and permanently labeled with accurate
  room and load descriptions.
• Breaker labeling legible: Panel schedule corresponds with installed circuits and is
  easy to read.
• Grounding and bonding verified: All metallic systems bonded per code; grounding
  conductors connected to panel and water line as required.
• Arc-fault and GFCI devices tested: All required circuits protected and tested for
  proper trip and reset function.
• Smoke and CO detectors installed: All detectors installed per code locations, powered,
  and interconnected.
• Exterior lighting and outlets tested: All outdoor fixtures and GFCI receptacles
  operational and weatherproof covers installed.
• Receptacles tested for polarity and voltage: Each receptacle tested for correct wiring,
  grounding, and voltage within acceptable range.
• Switches and dimmers tested: All control devices function correctly, dim smoothly,
  and control intended loads.
• Ceiling fans balanced and tested: Fans operate quietly, on all speeds, and without
  noticeable wobble.
• Appliance circuits verified: Dedicated circuits installed and energized for required
  appliances (oven, range, microwave, etc.).
• Lighting controls programmed: Smart switches, timers, and scenes configured to
  homeowner preferences if applicable.
• Doorbell and low-voltage systems tested: Verify chime, transformers, and any
  control wiring (security, data, A/V) are operational.
• Electrical trim complete: No exposed wiring; blank plates installed on all unused
  openings.
• Electrical devices clean and undamaged: No paint, dust, or scratches on trim or
  fixtures.
• Panel cover installed securely: Deadfront properly fitted, with all breakers seated and
  labeling visible.
• Final inspection passed: System approved by electrical inspector and ready for
  occupancy.
• Work area cleaned: All debris removed, fixtures wiped down, and site left in clean
  condition.